Foscam FI9800P Installation Guide

Installation Guide
Waterproof Junction Box
FAB99 is for Foscam Outdoor Mini Bullet IP Cameras,
FI9900P FI9800P FI9900EP FI9901EP, etc.
Location Sicker
wall
1
1. Put the Location Sicker on the wall and drill ve holes, four for small
and one for big.
2. Nail the rubber screws into the four small holes.
3. Thread wires through the big hole and the bottom cover.
4. Tighten the screws to x the bottom cover.
5. Put the silica gel plug at the junction of bottom cover and wires.
a
b
c
d
Screws: a b c d Silica Gel Plug: e Rubber Screw: f g h i
e
f
h
g
i
Version: 1.0
Model: FAB99

Foscam FI9800P Specifications

General

Type	IP security camera
PTZ control	Yes
Placement supported	Indoor & outdoor
Connectivity technology	Wired & Wireless
Form factor	Bullet
Product color	Stainless steel
Protection features	Water resistant
International Protection (IP) code	IP66
Full HD	No
Total megapixels	1 MP
Maximum resolution	1280 x 720 pixels
Video formats supported	H.264
Minimum illumination	0 lx
Sensor type	CMOS
Optical sensor size	1/4 \
Night vision distance	20 m
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology	10/100Base-T(X)
Interface	RJ-45
Ethernet LAN (RJ-45) ports	1
Power over Ethernet (PoE)	-
Power consumption (typical)	4.2 W
Sustainability certificates	RoHS
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 80 %
Fixed focal length	2.8 mm
Maximum aperture number	1.2
Harmonized System (HS) code	85258900

Weight and Dimensions

Depth	98 mm
Width	65 mm
Height	62 mm