Foster FS40 - Page 9

English
• Turn the machine o.
• Remove all ice from the container
• Prepare the soluon by dissolving the citric acid in warm water (max 40°C), according to the quanies
shown on the Previous table.
• Posion the internal switch in the cleaning posion (g 7).
• Pour the cleaning product into the evaporator tray (g 8)
• Turn the power to the machine on and wait for at least 2 hours.
• Aer two hours, switch the machine o and drain the soluon in the evaporator tray into the cabinet
(Fig 9)
• Replace the cap and pour clean water into the tray to ll it to capacity, and start the machine again.
• Repeat the operaon at least 5 mes to eliminate the presence of citric acid and saniser.
• Aer this me has elapsed, switch the machine o and remove the cap to discharge the water in the
evaporator tray, then replace cap.
• Finally, return the switch to ice mode.
• Aer the cleaning funcon, rinse the cabinet well.
• If the machine remains unused for long periods: Switch the machine o;
Remove all ice from the container;
Discharge all water;
Clean carefully;
Leave the container door ajar.
CLEAN
8
7 8 9
Starting the wash & sanitation Cycle
When handling citric acid and citric acid soluon