Fostex X-34 - Specifications

4
X-34
1. SPECIFICATIONS
DEFINITION
Specification Unit 0 dBV = 1 Vrms
Normal Fader Position
Input fader At 70 ~ 90 % position
Condition LINE IN / INSERT: -10 dBV / 1 kHz
Recorder: Input Monitor mode (REC - PAUSE)
Adjust input fader for -10 dBV at TAPE OUT.
Master fader At 70 ~ 90 % position
Condition LINE IN / INSERT: -10 dBV / 1 kHz
Recorder: Input Monitor mode (STOP)
Adjust master fader for -10 dBV at LINE OUT.
PAN: L (R)
MIXER SECTION
Standard Input
MIC IN
Connector Phone (unbalanced) / XLR-3 (balanced)
Input level -50 ~ -10 dBV
Impedance 10 kΩ or more
LINE IN / INSERT (RTN)
Connector Stereo phone (tip)
Input level -10 dBV
Impedance 10 kΩ or more
AUX RTN L (MONO) / R
Connector Phone
Input level -20 dBV
Impedance 7 kΩ or more
Standard Output
TAPE OUT 1 ~ 4 / LINE OUT L, R
Connector RCA pin
Output level -10 dBV
Load impedance 10 kΩ or more
MONITOR OUT L, R
Connector Phone
Output level -10 dBV
Load impedance 10 kΩ or more
INSERT (SEND)
Connector Stereo phone (ring)
Output level -10 dBV
Load impedance 10 kΩ or more
Phones Max. Output Level 20 mW or more (1 kHz, 16 Ω load)
Level Indication 5-dot LED meter X 6 (0 dB is indicated by 5-dot LED bargraph meter
when input / output level is -10 dBV with the above standard input /
master fader position settings.)
Mic Gain 40 ± 2 dB
Distortion
(With 400 Hz HPF & 30 kHz LPF) 0.05 % or less (Input: 1 kHz / 0 dBV signal, MIC GAIN: LINE, LINE
OUT: 0 dBV.)
0.2 % or less (Input: 1 kHz / 0 dBV signal, MIC GAIN:LINE,
PHONES: 3 mW / 16Ω.)