• Only process media that will not react dangerously to the extra
energy produced in other ways, e.g. through light irradiation.
• Accessories must be securely attached to the machine and
can’t come off by themselves.
• Always disconnect the plug before fitting accessories.
• The machine can only be disconnected from the mains supply
by pulling out the mains plug or the connector plug.
• When using PTFE-coated magnetic bars, the following has to
be noted:
Chemical reactions of PTFE occur in contact with molten or
solute alkali metals and alkaline earth metals, as well as with
fine powders of metals in groups 2 and 3 of the periodic
system at temperatures above 300°C-400°C.
Only elementary fluorine, chlorotrifluoride and alkali metals
attack it; halogenated hydrocarbons have a reversible
swelling effect.
• The voltage stated on the type plate must correspond to the
mains voltage.
• Don’t cover the machine, even partially e.g. with metallic plates
or film, which will result in overheating.
• Ensure the working plate is kept clean.
• Protect the machine and accessories from bumps and impacts.
• The minimum distance between the machines; the
minimum distance between the machine and the wall is
mini. 100mm.
Inspection
• Unpack the device carefully and check for any damages
which may have arisen during transit. Please contact
the manufacturer/supplier for technical support.
Note:
If there is any apparent damage to the device,
please do not connect the power line.
3
To Next Page
Loading...