14
EN
SPECIFIC SAFETY INSTRUCTIONS FOR DRILL PRESSES
1. DO NOT use the drill press until it is completely assembled and installed according to the instructions of this
manual.
2. FIX the
drill press on a supporting or flat surface. If the supporting or the flat surface move during use, FIX
them to the groun
d.
3.
START the drill press after removing all
objects (tools, discards, etc
..).
4.
DO N
OT start the drill press when the bit is in contact with the workp
iece.
5.
ONLY USE b
its, tools or other accessories provided with a spindle connection pin smaller than 13mm.
6. ALWAYS KE
EP your hands and fingers away from th
e bit or the tool.
7.
D
O NOT TRY to drill a workpiece which does not have a flat surface, unless you use a suitable horizontal
base.
8.
ALWAYS US
E a locking device to prevent the workpiece from turning during working
.
9.
USE re
commended speeds to drill the various materials according to the bit you are using.
10. BE
SURE that all locking handles are locked before starting the machine and that the transparent protection
of the spindle is in its positi
on.
11.
DO N
OT carry out any assembly or preparation tasks on the workbench when the drill press is working.
12. BE
SURE that the bit or the tool are not damaged and that they are properly blocked in the spindle before
use.
13. BE
SURE that the wrench of the spindle has been removed from the spindle before starting the
machine.
Only use the
spindle wrench provided with t
he drill press.
14.
AD
JUST workbench’s height and bit’s descent depth in order to prevent the bit from drilling the workbench.
15. ALWAYS switc
h off the machine before removing the chips from the workbench.
16. BE SURE tha
t big workpieces are correctly supported at workbench’s height during cutting.
17. DISCO
NNECT THE MACHINE FROM THE POWER SUPPLY, remove the bit or the tool before moving aw
ay
from the ma
chine.
18. REPLACE the missi
ng or damaged parts. Do not use the drill if all its parts do not work.
ENVIRONMENTAL PROTECTION
INFORMATION FOR USERS
Implementation of Directives 2011/65/EU, 2012/19/EU,, relative to reducing the use of hazardous substances in
electric and electronic appliances and the disposal of waste”, please take note of the following:
The crossed out wheelie bin symbol found on the appliance or the packaging indicates that the product
must
be dispo
sed separately from ordinary household waste when it reaches the end of its working
life.
The user must consign the unwanted appliance to an authorised waste disposal centre for electric and
electronic goods, or alternatively, hand it over to the relative dealer at the moment of purchasing a
new
applia
nce of the same type on a basis of a one to one
ratio.
Differentiated disposal to enable possible recycling or environmentally compatible elimination of the applianc
e,
help
s to limit undesirable effects on health and environment and promotes the reuse and/or recycling of the
materials that compose the appliance.
WARNING!
IN ACCORDANCE WITH THE RELATIVE LEGISLATION IN FORCE IN THE COUNTRY OF
USE, SANCTIONS WILL BE IMPOSED ON THE USER IF THE APPLIANCE IS DISPOSED OF
ILLEGALLY.
To Next Page
Loading...
Need help?
General
