33
Product in compliance with relative CE regulations.
It is forbidden to put your hands in this area, the machine is working. Danger of dragging / cutting.
It indicates that in the machine a laser pointing device is in use (see par. SAFETY
INSTRUCTIONS FOR THE LASER POINTING DEVICE).
Serial number / Year of production
ELECTRICAL CONNECTIONS
Use 230 V 50 Hz alternate voltage equipped with a earthing conductor to supply your machine. Ensure that the
power supply corresponds to this voltage, that it is protected by a differential and magnetothermal switch, and
that the earthing system is efficient. If your machine does not work when connected to a socket, check carefully
the power supply features.
Use an extension cable in order to connect the machine to the power supply.
EARTHING INSTRUCTIONS
If the tool does not work properly or in case of short-circuit, the earthing system provides the current with a less
resistance path and reduces the risk of electric shock. This tool has a plug to which a supply or extension cable
must be connected, which in turn must be connected to a socket correctly installed and earthed, in conformity
with local standards and regulations. Be sure that your earthing system is in good conditions and that your plug is
protected by a differential and magnetothermal switch.
Do not modify the plug of the machine. If it does not enter the socket, get a suitable plug installed by a qualified
person. If the earthing conductor is not correctly connected the risk of electric shock can occur. The conductor
which has the green insulating jacket (with or without a yellow line) is the earthing conductor. If you must repair or
change the supply cable, do not connect the earthing conductor to a low tension terminal.
Consult a qualified electrician or a person in charge of the maintenance if you have not understood or you have
some doubts on the earthing instructions.
Socket with earthing
system
Earth conductor
Machine’s plug
ELECTRICAL CONNECTIONS
To Next Page
Loading...
