SPECIFIC SAFETY INSTRUCTIONS FOR DUST COLLECTORS
The filtration housing contains a high speed fan blade that can amputate fingers, grab loose clothing and neckties,
and propel dust at high velocities. DO NOT OPERATE WITHOUT ALL PARTS IN PLACE.
Do not attempt to clean, remove the dust bags, or service the unit when the power is on. Turn the unit off and
disconnect the cord from the power source.
Static shocks are common in dry areas or when the relative humidity of the air is low. The use of a humidifier where
the dust collector is to be used will help raise the relative humidity, and may reduce static shocks.
Sparks inside the electrical parts can ignite flammable vapours or dust.
Do not vacuum, or use the dust collector near flammable or combustible liquids, gases, gasoline or other fuels,
lighter fluid, cleaners, oil-based paints, natural gas, hydrogen, or explosive dusts like coal dust, magnesium dust,
grain dust, or gun powder.
To avoid health hazards from vapours or dusts, do not vacuum toxic materials.
Do not use or store near hazardous material.
Do not use outdoors or on wet surfaces.
Put the unit on a stable, level surface.
Position the vacuum hose and electric cord away from traffic areas.
Do not allow the unit to be used as a toy. Close attention is necessary when used by or near children.
Do not leave the dust collector plugged in. Unplug from the outlet when not in use and before servicing.
To avoid injury from accidental starting, unplug the power cord before changing or cleaning the filter/dust bag or
chip bag.
Do not use without the filter/dust bag and/or chip bag in place.
Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.
Turn off the controls before unplugging.
Do not use with a damaged cord, plug, or other parts. If your dust collection system is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into water, return it to an authorised Service
Centre.
Do not pull or carry by the cord, use the cord as a handle, close the door on the cord, or pull the cord. Keep the cord
away from heated surfaces.
Do not handle the plug of the dust collector with wet hands.
To Next Page
Loading...