bracket consult manufacture
instructions (Fig. 3).
8. Using two supplied clamps, mount the
reservoir to the brackets. Utilize the
slots in the bracket to locate clamps.
Do not feed the clamps through the
slots in the brackets (Fig. 4).
9. Check that the suspension has proper
clearance by steering completely in
both directions.
10. Reinstall both front wheels and torque
to factory specifications.
11. For maximum performance of your
new Internal Bypass Shocks, Fox
recommends at ride height that there
be between 5.50” to 7.75” of shaft
showing.
Fig. 4: Driver side
Fig. 3: Driver side
4
To Next Page
Loading...
Need help?
General