7
2. Quick Setup
Once connected to a power adapter with 48DVC and a 10G Ethernet cable, and the
ethernet link to internet CBSD server and ePC via switch or router and CBSD was for
CBRS LTE function use, and it’s ready to go. The IP addresses are dynamically obtained
through internal DHCP and check the RF LED for service on.
The AIO smallcell support the management system with TR069 for LTE function,
NetCONF/Yang for NR system. It is easy to connect to FNMS (Fii Network Management
System). And it is easy to use the FNMS to control the AIO smallcell with CM/FM/PM and
upgrade firmware.
3. Installation guide
This chapter briefly describes all the steps for the installation of the small cell in terms
of both hardware and software. The small cell shown here is pole mounted.
To Next Page
Loading...
Need help?
General
