5
BATTERY
The Command Series requires four (4) AA batteries. Acceptable battery
types include: Alkaline or rechargeable Alkaline, rechargeable NiMH or
LiFeS
2
(all are 1.2 to 1.6 volts each).
Do not leave batteries in the Battery Pack for periods longer than three
(3) months without use.
Be sure to check the Battery Pack every month for battery corrosion.
NOTE: Corrosion from leaking batteries is NOT covered by the warranty.
NOTE: Mixing of new and used, or different brand batteries is not
recommended as this could lead to leakage or explosion.
BATTERY INSTALLATION
(WATCH THE VIDEO: FOXFURY.COM/VIDEOS)
1. Open all six (6) of the Battery Pack Tabs.
2. Insert four (4) AA batteries. Reference the plus (
+
) and minus (
-
) symbols
located on the inside of the Battery Pack for proper installation.
REASSEMBLING THE BATTERY PACK
1. Once batteries are installed, test the light’s performance by activating the
Power/Mode Switch located on the top of the light.
2. Secure the Battery Pack Cover by snapping all six (6) Battery Pack Tabs.
A ‘click’ should be heard as the snaps are shut.
NOTE: Make sure the Battery Pack is properly closed to maintain a
water tight seal.
1
1
1
2
2
2
To Next Page
Loading...