7) The display on the TX-24 will display “Transfer”. When it’s done, the
display will say “Unplug Cable Press Send”.
8) Unplug the cable from the TX-24 first, followed by the main unit.
NOTE: Always unplug the cable from the TX-24 before the main
unit. If you unplug the main unit end first, this could result in the
TX-24 needing to be manually reset by momentarily disconnecting
the battery.
9) Press and hold the send button for several seconds. The playlist has
been transferred.
NOTE: This process may take a few seconds. DO
NOT turn off the TX-24 or SPITFIRE during this
process.
FCC Information
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that the interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or circuit different that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation of this device.
Modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment under FCC rules.
Industry Canada Notice
Operation is subject to the following two conditions:
This device may not cause harmful interference and
This device must accept any interference received, including interference that may
cause undesired operation.
To Next Page
Loading...