that position and not overwrite the current sound. If you would like to
remove sounds from the right side column before adding new ones,
simply highlight the sound, and click on the “Remove From List”
button, located between the two columns.
If you would like to relocate a sound in the right sound column, you can high
light the sound and then type the position number that you would like to move it
to in the “Move To” box (located below the right side column). This will move
the sound to your designated number. You can also highlight the sound that
you wish to move on the right column, and then click on the up or down arrows
below the right side column to move the sound one position at a time. If you
would like to reset your list at any time, click on the Clear/Reset List button
located on the right side of the screen. This will reset the list to its initial sounds.
8) Click on the “Copy to Caller” button located on the right side of the screen.
Your sounds will now be programmed to your SPITFIRE.
IMPORTANT NOTE: Your SPITFIRE will play .FXP, .mp3 and .wav
files. Other file types are not supported. Although you may store
.FXP sounds on your computer for later use, they cannot be played
on your computer, or on any audio player other than a FOXPRO
®
caller.
4.3 DOWNLOADING NEW PLAYLIST TO TX-24
Program your sounds into the SPITFIRE as outlined in the instruction manual.
Make certain that you do not use the same number for more than one sound!
Note that the transmitter can only display 21 characters per line. The first 3
characters must be the sound number, from “000” through “023”. Place a space
between the sound number and the sound name. 17 characters remain for the
sound name. Although the sound name can have more characters, the TX-24
will only display the first 17 characters. Any additional ones will not be
displayed.
NOTE: You must have 24 sounds labeled 000 – 023 programmed into the
Spitfire before you can download a playlist. You will also need to obtain a
3.5mm male-to-male stereo patch cable for this process.
1) Disconnect all accessories from the SPITFIRE (i.e. speakers or decoy)
2) Turn the power off on both the SPITFIRE and the TX-24.
3) Connect patch cable from the sound upload jack on the TX-24 to the
AUX jack on the SPITFIRE.
4) Turn on the TX-24
5) After being powered on, the TX-24 display will say “Turn On Caller”
6) Power on the SPITFIRE
To Next Page
Loading...