Page | 5
1.0 OPERATING GUIDE
This manual will explain all features of your new FOXPRO
®
WILDFIRE in depth
to help ensure the best overall experience. The Operating Guide will provide
you the steps on how to get started.
It is strongly recommended that to fully understand the features and
abilities of your FOXPRO
®
WILDFIRE, that you read this manual in its
entirety.
1.1 INSTALLING BATTERIES IN YOUR WILDFIRE
Since your WILDFIRE is shipped from the factory with no batteries installed,
the first step is to install batteries. The WILDFIRE requires 4 “AA” batteries.
Alkaline batteries are recommended for the best performance. You can
expect to achieve runtimes in excess of 20 hours on one set of batteries. You
can use rechargeable NiMH batteries, but they must be charged externally as
the WILDFIRE does not have a charge jack.
1) Remove the battery door. The battery door is located on the side of
the caller (see image on page 4).
2) Orient the batteries as per the directions shown in each cavity within
the holder. Note that the battery polarity alternates.
3) Replace the battery door after the batteries are installed.
1.2 INSTALLING THE BATTERY IN YOUR TX9
The TX9 transmitter operates from one “9V” battery. Please use a high
quality alkaline battery. (See section 3.0 for more details on the TX9)
1) Remove the battery compartment cover located on the rear of the
transmitter.
2) Connect the “9V” battery to the battery wire.
3) Replace the battery compartment cover after the battery is installed.
1.3 OPERATING THE WILDFIRE WITH TX9 REMOTE CONTROL
1) Turn on the TX9 remote control by pressing and holding the “PWR”
button for a few seconds.
2) Use the sound up or sound down arrow buttons to scroll through your
available sounds. The selector bar highlights the sound that is currently
selected.
To Next Page
Loading...