Foxwell BT705 - Page 16

BT705 Battery Analyzer User’s Guide - English Version_V1.00
16
To start cranking test:
1. Press the ENTER button for cranking test.
2. Start the engine when prompted.
3. The tester displays the decision on the starter system, cranking voltage, and cranking time in
milliseconds.
No.
Test Results
Interpretation
1
CRANKING
NORMAL
The starter voltage is normal and the battery is fully
charged.
2
LOW
VOLTAGE
The starter voltage is low and the battery is fully charged.
3
CHARGE
BATTERY
The starter voltage is low and the battery is discharged.
Fully charge the battery and repeat the starter system
test.
4
REPLACE
BATTERY
Battery must be replaced before the starting system can
be tested.
5
NO START
No vehicle start detected.
6
CRANKING
SKIPPED
A start was not detected.
4. Press ENTER button to proceed with the charging system test, Print button to print the test
results, BACK button to return to the main menu.
NOTE
For an in-vehicle test, the display alternates between the test results and the message. Press
ENTER for charging test.