Do you have a question about the Foxydry AIR and is the answer not in the manual?
Essential tool for accurate measurements during installation.
Required for accessing ceiling installation points safely.
Used for marking drilling points on the ceiling.
Necessary for creating mounting holes in the ceiling.
Tools for tightening nuts, bolts, and specific screw types.
Tools for gentle tapping and cutting plastic straps.
Detailed steps for assembling the FOXYDRY unit.
Covers non-toy status, small parts, and general liability.
Warns about maximum load capacity and ceiling requirements.
Stresses qualified installation, proper electrical connection, and grounding.
Advises on safe operation, avoiding pinch points and rain exposure.
Cardboard template for accurate hole marking.
Includes the central body and the remote control unit.
Details side structures and various rails for drying clothes.
Lists included screws, plugs, and plastic covers.
Provides the maximum space occupied by the unit in its states.
Guide to marking and drilling ceiling holes using the template and drill.
Ensure plugs match the ceiling material type.
Guide to inserting plugs and securely tightening nuts.
How to fix the main body to the ceiling plugs and tighten fasteners.
Screw the scissor-type structures onto the main body ends.
Guide for sliding cables into connectors and securing with covers.
Cut straps and disconnect power before connecting the unit.
Procedure for connecting the FOXYDRY to the main electrical supply.
Steps to register the remote control with the FOXYDRY unit.
Verify activation of maximum descent and ascent limit switches.
Fasten thin rails by hand and tighten all screws securely.
Screw the plastic covers back onto the ends of the central body.
Use buttons to lower, raise, and stop the drying rack at intermediate heights.
Turn light and fans on/off; fans auto-shutoff after 3 hours.
Unit stops if it rests on an obstacle; clear obstacle or reset.
Unit stops for loads >35kg or after 4 mins continuous use (thermal block).