PREINSTALLATION CHECKLIST - ALL INSTALLATIONS
ATTENTION: READ CAREFULLY BEFORE ATTEMPTING TO INSTALL OR OPER-
ATE YOUR PUMP. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL
SAFETY INFORMATION AND ADDITIONAL INSTRUCTIONS INCLUDED WITH
EQUIPMENT. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN
PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN FOR FUTURE
REFERENCE.
1. Make sure that the pump is plugged into a properly grounded electrical receptacle.
Use an Underwriters Labo¬ratory listed circuit analyzer to test for proper installation
of the circuit and ground. Any service to circuits or receptacles should be conducted
by a qualified licensed electrician.
2. Do not remove the ground pin from the plug under any circumstances. If the ground
pin is damaged, replace the power cord or plug before use.
3. All electrical installations must conform to the requirements of the National Electric
Code and all local codes.
4. It is strongly recommended that the unit be plugged into a GFI protected circuit.
5. Disconnect power before servicing the pump or motor by unplugging the unit from
the outlet.
6. Do not touch the motor when operating and allow the motor to cool before
touching it afterwards.
7. This pump is designed for water only. It has not been evaluated for pump¬ing of
chemicals.
8. Do not use this product to pump flammable or explosive liquids.
9. Do not use this product in hazardous environments or any¬where a spark
could potentially ignite explosive gases.
10. Do not handle this product with wet hands or while standing in water or on a
wet or damp surface.
11.the pump is supplied with an automatically resetting thermal overload device and
can restart without warning.
12. Do not submerge the pump or motor in water.
13.Secure the discharge line before starting the pump. An unsecured hose can whip,
possibly causing personal injury or property damage.
-1-
To Next Page
Loading...