14. Provide a means of pressure relief if the pump dis-charge can be shut off or
obstructed. Pumps operat-ing against a closed discharge can create very hot pumped
liquid, which can cause burns.
15.Do not operate this product while unattended.
16. Product is portable, and not intended to be permanently installed outdoors.
If installed outdoors, care should be taken to protect the unit from rain and other
elements of the weather.
17.According to the state of California (Prop 65), this product contains chemicals
known to the state of California to cause cancer and birth defects or other reproduc-
tive harm
1. Make certain that the power source conforms to the requirements of the equipment
as stated on the product nameplates.
2. Check hoses for weak or worn conditions before use and make certain that all
connections are secure.
3. Periodically inspect the pump for damage and perform routine maintenance as
required.
4. The maximum temperature of the pumped liquid must not exceed 120° F. The
minimum allowable temperature is 40° F.
5. Use a screen or strainer on the inlet to prevent solids from entering the pump.
6. To avoid internal pump damage, pump should not be run for more than five minutes
while attempting to prime.
DESCRIPTION
This portable utility pump is designed to be used as a transfer pump for such applica-
tions as emptying water heaters, swimming pools, livestock tanks, boats, etc. Pump
can also be used for an intermittent pressure booster for applications such as
washing cars, cleaning driveways, etc. The motor is air cooled. It is NOT designed to
operate under water.
INSTALLATION
Always disconnect power source before attempting to install,
service or maintain the pump. Never handle a pump with wet hands or when standing
on wet or damp surface or in water. Fatal electrical shock could occur.
1.A ground fault circuit interrupter (GFCI) is recommended.
Risk of electrical shock. This pump is supplied with a grounding conductor and
grounding type attachment plug. A grounded receptacle in conformance with current
NEC and local codes must be used
2.Figure 1
-2-
To Next Page
Loading...