OPERATION
Pump must be filled with water before operation. Running the
pump dry or pumping any sand or other abrasives will cause damage to the shaft seal
or impeller and void the warranty
Figure 3
1. Product is portable, and not intended to be
permanently installed outdoors. If installed outdoors, care should be taken to protect
the unit from rain and other elements of the weather. This unit is not waterproof or
weatherproof and is not intended to be used in showers, saunas, or other potentially
wet locations. The motor is designed to be used in a clean, dry location with access
to adequate cooling air. Ambient temperature around the motor should not exceed
104°F (40°C).
2. Remove priming plug and fill with water. Reinstall plug.
To help with the priming of the pump, a foot valve can be installed
on the inlet line. The use of a foot valve is strongly recommended to be installed on
inlet lines lifting over five feet.
3. Plug power cord into GFCI protected electrical outlet. The pump will prime in a few
minutes, depending on inlet line length.
To avoid internal pump damage, if after five minutes the pump
has not begun pumping water, turn off the pump, remove priming plug, re-fill pump
with water, reinstall priming plug and plug pump back in.
4. In the case of pressure boosting, turn water on before starting pump. This force
primes the pump. Then, plug power cord into GFCI protected electrical outlet.
• shut down switch
5. Unplug cord to turn unit off.
MAINTENANCE
Let pump cool for at least 20 minutes before attempting to service.
Motor may be extremely hot. Personal injury may result.
1.Pump should be checked periodically for proper operation.
-4-
To Next Page
Loading...