34
Engine lubricant oil level check
The check must be executed when the engine is disconnected and
possibly cool.
Only proceed with the engine stopped and at low temperature, in
order to avoid the risk of burning.
Make sure the machine is on a flat surface.
Use the oil dipstick (2) to check that the lubricant oil level is
between the "Min" and "Max" limits.
Whether it should be difficult to make the evaluation, proceed
cleaning the oil dipstick (2) using a clean cloth with no rag grinding
and put it back in its slot. Draw it off again and check the level.
If the level is insufficient, it is necessary to top up with lubricant oil
which meets the international specifications API CJ-4 / ACEA E9,
as indicated in the REFILLING table: remove the lubricant oil cap
(1) and pour engine lubricant oil through the hole.
Use the oil dipstick (2) to check that the lubricant oil level in the
oil sump (3) does not exceed the "Max" limit.
To Next Page
