32
Do not smoke or use open flames during this operation.
Do not inhale the vapours that exit the filter.
Pay attention to the electric fuel pre-heater (if installed)
and the relative electrical connection.
Do not fill the new fuel filter before placing it on the
support in order to prevent harmful impurities from
entering the fuel circuit and the injection system.
Eliminate the consumables and any materials in
contact with them (for example, filters) in accordance
with current regulations.
The FPT Technical Service Network workshops are
equipped for this purpose.
CAUTION!
Ensure that any fuel coming out of the vent plug or
drain screw does not dirty the auxiliary members' drive
belt and is not dispersed into the environment.
Never loose connectors of the high-pressure fuel pipes
and of the common rail in any way.
If it is necessary to speed up the residual air bleeding
phase, use the hand pump also while starting.
To Next Page
