16
ENGLISH
4.4 - Device configuration
From this menu, you can choose the wireless device to be programmed; see the manuals of
each device.
4.4.1 Input sensor programming
It is possible to select/program the input sensors acquired in the wire radio interface from the
device list (identified with MAG: magnetic and IR: infrared).
Associated line: menu available for wireless inputs (WL sensors). It is possible to display the as-
sociation between a wireless device and the line in the control panel.
Filter: only for magnetic wireless detectors. See their manuals for programming.
NB: after a device filter is modified, carry out a tamper event to verify the acquisition of the new
configuration.
4.4.2 Siren programming
The sirens (identified by the SIR symbol) acquired in the wire radio interface can be selected/
programmed from the device list.
Associated output: menu available for the wireless outputs (sirens). It is possible to display the
association between a wireless device and the control unit’s output.
Warnings (available for the outputs only): it is possible to select the activation events of the wire-
less output. The activating events are:
- Partial or total arming: the proper arming of the control panel is signalised by 2 beeps from the
buzzer and 2 flashes from the LEDs.
- Partial or total disarming: the proper disarming of the control panel is signalised by 3 beeps from
To Next Page
Loading...
Need help?
General
