Need help?Do you have a question about the Fractal Audio Axe-Fx III and is the answer not in the manual?
Overview of the Axe-Fx III as a powerful guitar processor with expanded capabilities.
Detailed description of the Axe-Fx III's front panel controls and features.
Detailed description of the Axe-Fx III's rear panel connectors and I/O.
Using the Axe-Fx III as an audio interface and for MIDI control via USB.
Setup for connecting to full-range flat response speakers or studio monitors.
Explanation of the Axe-Fx III's 512 preset slots and rig structure.
Instructions for saving modified presets and editing names.
Introduction to Scenes (states within a preset) and Channels (block states).
Using the grid's VU meters and amp block level for consistent loudness.
Detailed explanation of the Amp block, its types, and parameters.
Detailed explanation of the Cab block for speaker simulation.
Step-by-step guide to assigning modifiers to parameters.
Process for updating the Axe-Fx III firmware using Fractal-Bot.
General| Model | Axe-Fx III |
|---|---|
| Category | Recording Equipment |
| Device Type | Multi-Effects Processor |
| Type | Digital Effects Processor |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Sampling Rate | 48kHz |
| USB Audio | Yes |
| MIDI Control | Yes |
| Ethernet | Yes |
| Effects | Yes |
| User Presets | 512 |
| Display Resolution | 800 x 480 |
| Storage | User presets |
| A/D/A Conversion | 24-bit |
| USB | USB |
| MIDI | In/Out |
| Effects Types | Delay, Reverb, Modulation, Distortion |
| Amp Models | 200+ |
| Display | Yes |
| Connectivity | Ethernet, USB, MIDI |
To Next Page
