22
Continuous pressing of »+» (C) or »-« (E) sensors the power level is
automatically increased or reduced.
Another procedure is to change power in steps is by intermediate touching
of relevant sensors.
Setting is always possible for one hotplate only at the time.
Power display indicates »0«, or „H“, depending on the existing temperature
of the hotplate (see Section Remaining Heat Indicator).
You can also turn the hotplate off prior the end of cooking and use the
remaining heat, and save energy.
Turning coking zone off
• Selected hotplate must be activated.
• Touching the hotplate sensor »-» (E) set the power level to »0«. After 10
seconds the hotplate is turned off.
Fast deactivation
• Selected hotplate must be activated.
• Press both (+) and (-) (C and E) sensors simultaneously, and the hotplate is
immediately switched off.
Turning the hob off
The hob can be switched off any time by pressing the sensor (A).
Child lock
By activating the child lock protection you can stop the operation of the appliance,
the use of hotplates, protecting the children from accidental start and eventual
injury.
Activating child lock
• Switch all hotplates off (setting “0”).
• Touch sensor (A) and activate the hob (in case it was idle). All displays indicate
»0«.
• Press sensors (D +/-) simultaneously. After the beep press the sensor (+) again.
All displays indicate letter »L«, which disappears after 20 seconds. Child lock is
now activated.
Turning child lock off
• Protection is switched off by pressing the sensor (A). All displays indicate the
letter L.
• Press simultaneously sensors (D +/-). After the beep press sensor (-) again.
Child lock is now off.
Remaining heat indicator
Glass ceramic hob also features remaining heat indicator “H”. As long as the
symbol “H” is on after the hotplate was switched off, the remaining heat may be
used for warming up food or for melting.
Even when the symbol “H” disappears, the hotplate may still be hot.
Be careful of burns!
Dual-circuit cut-off
▪ The dual-circuits are immediately connected upon activating a respective
cooking zone(C).
▪ By pressing the multi-circuit key (F) of an activated cooking zone (cooking stage
level ≠"O") the corresponding outer circuit of the respective cooking zone can be
cut oH any time. An activated outer circuit is displayed by an additional LED (G).
▪ Pressing the multi-circuit key (F) again connects the outer circuit/s any time, the
respective LED's flash up again.
Operation time limit
For improved safety, your cooking hob is fitted with a device that limits the
duration of the cooking hob operation for each cooking zone respectively. The
duration of operation is measured from the last change made to the power level
settings for a particular cooking zone. If the power level is not changed for a while,
the cooking zone will automatically be switched off after a certain period of time
which depends on the power level (see table below).
Level 1 2 3 4 5 6 7 8 9
Limit Time (h) 6 6 5 5 4 1,5 1,5 1,5 1,5
To Next Page
Loading...
Need help?
General
