INSTALLATION
mounted cupboard.
specified on the rating plate.
only be replaced by a qualified electrician. If the plug is no
longer to accessible following installation, an all-pole
disconnecting device must be present on the installation
side with a contact gap of at least 3mm.
be used. Overloading can result in a risk of fire.
The accessible surface may
be hot during operation.
installed earthed socket.
Schuko plug or a three-pole power cable with free
terminals.
2.The appliance is supplied with a power cable and a
3.The appliance must only be connected to a properly
1.The appliance can be installed in a 60cm wide wall-
4.The mains voltage must correspond to the voltage
5.The socket must be installed and connecting cable must
6.Adapters, multi-way strips and extension leads must not
To Next Page
Loading...
Need help?
General
