– 8 –
FHSM 604 4I / FHSM 603 3I / FHSM 603 3I DZ / FHSM 804 4I /
FHSM 803 3I / FHSM 302 2I / FHSM 604 4I WH / FHSM 603 3I DZ WH
EN
Electrical connection
Connection terminals are revealed when the connection box cover is removed.
FRANKE hobs are supplied with a power cable.
Make sure the characteristics of the household electrical system (voltage,
maximum power and current) are compatible with those of the appliance.
If the appliance is to be permanently connected to the power supply:
Install a device that enables disconnection from the power supply, with a contact
opening distance (3 mm) that ensures complete disconnection in category III
overvoltage conditions.
Ensure the following:
– Check that plug and socket are correctly dimensioned, according to the
appliance rating plate. Avoid the use of adapters and shunts as these could
cause overheating and burns.
– The plug and the socket can be easily reached and are positioned so that no live
part is accessible when inserting or removing the plug.
– The appliance does not rest against the plug when installed in the worktop.
– When replacing the power cable, please use the type cable indicated in figure 1
on pages 4 and 5.
– The earthing wire must be connected to the terminal marked with the earthing
symbol.
– The connection cable must lead through the relief safety device, protecting it
from accidental pulling out.
After electrical connection
Switch on all the hotplates for about 3 minutes to check the proper function.
Power limitation settings
Power limitation setting is possible for all the following models: FHSM 604 4I, FHSM
603 3I, FHSM 603 3I DZ, FHSM 804 4I, FHSM 803 3I, FHSM 604 4I WH, FHSM 603
3I DZ WH.
– Setting is possible only during the first two minutes after plug in the
appliance.
– The touch has to be unlocked and all heaters have to be switched off.
– The factory power setting is the maximum level.
– If there is a black out, power level set remains unchanged.
Example of power limitation setting of a four cooking zones hob (FHSM 604 4I /
FHSM 804 4I / FHSM 604 4I WH):
Press at the same time all the four cooking zones and hold it until you can hear a
signal.
To Next Page
Loading...
Need help?
General
