Ice Maker Installation
Unpacking
This unit is an ice maker only. It requires a separate ice storage bin.
Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data labels on
your ice maker.
Remove tape and glue from your ice maker before using:
? To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or
glue residue can also be easily removed by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water and dry with a soft cloth.
? Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners
to remove tape or glue. These products can damage the surface of your ice maker.
Location Requirements
? This ice maker should be installed by qualified personnel.
Installation clearance
TOP VIEW
To Next Page
Loading...
