Need help?Do you have a question about the Franklin Electric PUMPTEC and is the answer not in the manual?
General| Frequency | 50/60 Hz |
|---|---|
| Overload Protection | Yes |
| Underload Protection | Yes |
| Short Circuit Protection | Yes |
| Phase Loss Protection | Yes |
| Locked Rotor Protection | Yes |
| Surge Protection | Yes |
| Enclosure Rating | NEMA 4X |
| Protection Features | Overload, Underload, Short Circuit, Phase Loss, Locked Rotor, Surge |
| Operating Temperature | -20°C to 60°C |
Details the Pumptec's function, optimization, and key features like protection and indicator lights.
Covers initial setup steps, including cover removal and setting the circuit board jumper for motor horsepower.
Illustrates wiring configurations for 2-wire and 3-wire motor installations, including Pumptec placement.
Guidance on adjusting the time-out and underload trip sensitivity settings for the Pumptec.
Explains the function of the POWER indicator light on the Pumptec unit.
Details the conditions indicated by the LOAD indicator light (dry well, underload, overload).
Describes the meaning of the VOLTAGE indicator light (under/over voltage).
Explains the 'Rapid Cycle' condition indicated by simultaneous flashing of LOAD and VOLTAGE lights.
Troubleshooting steps for when the Pumptec unit displays no indicator lights or power.
Diagnoses issues for solid or flashing LOAD lights, indicating underload or overload conditions.
Covers troubleshooting for high or low voltage conditions indicated by the VOLTAGE light.
Guides on resolving 'Rapid Cycle' conditions indicated by flashing LOAD and VOLTAGE lights.
Details the warranty period, coverage, and general exclusions for the product.
Lists specific conditions and actions that will automatically void the limited warranty.
Provides the toll-free number for installation and troubleshooting assistance from Franklin Electric.
To Next Page
