What happens if there's an over current in Franklin Electric SUBMONITOR CONNECT MT2211?
The Franklin Electric Relays will trip if the measured current is greater than the trip point setting for a duration that exceeds the over current trip time setting.
What happens if Franklin Electric SUBMONITOR CONNECT MT2211 have over voltage?
The Franklin Electric Relays will trip if the average of the 3 line-to-line voltages exceeds the nominal voltage setting by the over voltage percentage setting continuously for a time exceeding the over voltage trip time setting.
What happens if Franklin Electric Relays have under voltage?
The Franklin Electric Relays will trip if the average of the 3 line-to-line voltages is lower than the nominal voltage setting by the under voltage percentage continuously for a time exceeding the under voltage trip time setting.
What happens if Franklin Electric Relays have over power?
The Franklin Electric Relays will trip if the measured kW is greater than the kW trip point setting continuously for a time that exceeds the over power trip time setting.
What happens if Franklin Electric SUBMONITOR CONNECT MT2211 Relays have under power?
The Franklin Electric Relays will trip if the measured kW is less than the kW trip point setting continuously for a time that exceeds the under power trip time setting.
What happens if Franklin Electric SUBMONITOR CONNECT MT2211 have voltage phase unbalanced?
The Franklin Electric Relays will trip if any of the 3 measured line-to-line voltages deviates from the average line-to-line voltage by a value greater than or equal to the voltage phase unbalance trip percentage setting for a time exceeding the voltage phase unbalanced trip time setting.
What happens if Franklin Electric SUBMONITOR CONNECT MT2211 have current phase unbalanced?
The Franklin Electric Relays will trip if any of the 3 measured phase currents deviates from the average current by a value greater than or equal to the trip percentage setting.
What happens if Franklin Electric SUBMONITOR CONNECT MT2211 have voltage phase loss?
The Franklin Electric Relays will trip if the L-G voltage of any phase is more than 40% lower than the average voltage.
What does unexpected current flow mean in Franklin Electric Relays?
The Franklin Electric Relays will alarm if the starter detects current flow above a threshold of 0.2 A while the starter is in the stopped state.
General| Category | Relays |
|---|---|
| Manufacturer | Franklin Electric |
| Model | SUBMONITOR CONNECT MT2211 |
| Frequency | 50/60 Hz |
| Communication Protocol | Modbus RTU |
| Housing Material | Plastic |
Describes the formatting of safety alerts like DANGER, WARNING, CAUTION, and NOTICE.
Discusses wiring guidelines, branch protection, and electrical connection procedures.
Guides through initial setup, menu navigation, and entering basic parameters.
Details various motor protection mechanisms like overload, temperature, and insulation checks.
Describes the mobile app for wireless configuration, control, and monitoring.
Guides on diagnosing issues using self-diagnostics and accessing the fault log.
To Next Page
