Need help?Do you have a question about the Fransgard V-6500 and is the answer not in the manual?
Mounting the forestry winch in the 3-point linkage and adjusting the PTO shaft length.
Daily PTO shaft and turning plate greasing, weekly chain lubrication.
Ensuring cable is fixed, PTO shaft mounting, clutch adjustment, and proper winching/transport.
Ensuring proper training, manual reading, keeping clear of moving parts, and safe log handling.
Disengage PTO for service, use only original parts, and avoid modifications.
Avoid sideways winching exceeding 30 degrees, stay alert, and do not operate when fatigued.
Verify the large 1" lock nut (Nut C) is tightened and secure on the main shaft.
Loosen the two clutch adjustment bolts (Bolt B) prior to making adjustments.
Pull clutch cord, align arm to stop, and tighten bolts (Bolt B) until resistance is felt.
Pull wire through holes 2, 3, and out through hole 4.
Mount block 5, introducing only 5 mm of wire, and fasten with the supplied allen screw.
Pull wire back so fixing block is inside the toothed rim, close to hole 4.
To Next Page
General