Free2Move eSolutions easyWallbox - Page 332

10
2. SAFETY
2.1. Intended purpose of easyWallbox
easyWallbox is only intended for xed mounting. It can be installed and used
to charge electric vehicles both indoor (garages, company depots with restricted
access, etc.) and outdoor (private land, car parks, etc.), in compliance with
chapter 4 indications and local regulations.
The device can be used exclusively to charge full-electric or hybrid
vehicles compatible with Type 2 connectors, as in IEC 62196-2; it is not
compliant with other vehicles or devices. easyWallbox is a piece of Class I
Equipment. Therefore, it requires a proper earthing connection, by plug
and socket-outlet. The optional function for ventilation is not supported by
easyWallbox. Some countries apply regulations that require supplementary
protection from the risk of electrocution. In any case, the instructions for use
in the manual and any additional documentation must be read before using
easyWallbox. easyWallbox should be connected to a power supply protected
by an RCD and an overcurrent protective device. The RCD should have a rated
residual operating current not exceeding 30 mA, be at least type A, and should
comply with one of the following standards: IEC 61008-1, IEC 61009-1,
IEC 60947-2 and IEC 62423. The overcurrent protective devices should comply
with IEC 60947-2, IEC 60947-6-2, IEC 61009-1 or the relevant parts of
IEC 60898 series or IEC 60269 series.
2.2. Use not in accordance with the intended purpose
Use of easyWallbox is only safe if it conforms to the intended purpose.
Dierent use and unauthorised modications to the device are considered as
non-compliant and so unacceptable. The user is responsible for the use and is
liable for any dangerous situations or situations contrary to the legal provisions
applied in their country.
Free2Move eSolutions S.p.A. does not assume any liability for damage
caused by non-compliant use or unauthorised modications to the
device.