Free2Move eSolutions easyWallbox - Page 341

19
4. INSTALLATION
4.1. Choice of position
easyWallbox is designed for indoor and outdoor use, only for xed wall
mounting, and therefore cannot be used in dierent spaces where its continual
movement is required.
Before installing the device, check the feasibility. In detail, the position chosen
for the installation of easyWallbox must:
 be on a vertical and at surface, as shown in 4.5; weak surfaces that do not
ensure robust resistance must be avoided
 allow easy connection to the power supply and the electric vehicle to charge
 not be an obstacle to the movement of the electric vehicles to charge
 not have material or equipment on the whole of the surface required for
the installation
 respect local legislation on electrical installations, re prevention measures
and emergency exits in the installation site.
easyWallbox should not be installed on a pole/column or
pre-existing piping.
easyWallbox must not be installed in places:
 at risk of explosion (EX environment)
 used for escape routes
 where articles may fall on it (e.g. suspended ladders or car tyres) or where
it is likely to be hit and damaged (e.g. close to a door or in vehicle operating
spaces)
 where there is a risk of pressurised jets of water (e.g. because of washing
systems, power washers or garden hoses)
 it cannot be installed on non-permanent walls
 it cannot be installed on walls in inammable material or covered with
inammable material (e.g. wood, carpet, etc.).
In Italy, easyWallbox must not be installed in public areas,
as in IEC 61851-1.