Freedom Scientific TOPAZ

Questions and Answers

T
Terri RamosAug 17, 2025
How to decrease the magnification level on Freedom Scientific TOPAZ?
- D
  Danielle KellyAug 18, 2025
  Turn the MAGNIFICATION dial to the left to decrease the magnification level.
A
Amanda BowmanAug 20, 2025
How to increase the magnification level on Freedom Scientific Magnifiers?
- J
  Johnny OconnorAug 20, 2025
  Turn the MAGNIFICATION dial to the right to increase the magnification level.
A
akaufmanAug 23, 2025
What to do if Freedom Scientific Magnifiers TOPAZ is connected to a television, but no magnified image appears on the television screen?
- G
  Gloria FischerAug 23, 2025
  First, ensure that the television is on and set to the correct video input channel. Next, check that the television connector cable is securely connected to both the appropriate TOPAZ port and the video input jack on your television.
D
Danielle MacdonaldAug 25, 2025
What to do if the screen is blank on Freedom Scientific TOPAZ?
- L
  Luke LloydAug 26, 2025
  First, make sure the power is on and the power light for the monitor is illuminated. Verify that all power cables are properly connected. If the screen is still blank, try reducing the magnification level or pressing the blue VIDEO MODE button to switch to a different video mode.
V
Valerie EwingAug 28, 2025
What to do if the image on the screen of Freedom Scientific Magnifiers is too bright, or there is a glare?
- K
  Kevin VaughnAug 28, 2025
  Try using the yellow BRIGHTNESS dial to reduce the brightness. Alternatively, press the blue VIDEO MODE button to switch to a different video mode.
M
Michelle MillerAug 30, 2025
What to do if the image on the screen of Freedom Scientific TOPAZ Magnifiers is too dark?
- S
  Samantha KnoxAug 30, 2025
  Try using the yellow BRIGHTNESS dial to increase the brightness. You can also press the blue VIDEO MODE button to switch to a different video mode.
Y
yorkseanSep 2, 2025
What to do if Freedom Scientific TOPAZ Magnifiers unit does not turn on?
- I
  illoydSep 2, 2025
  Make sure that both the TOPAZ and the monitor are plugged in. Check that the outlet has power and isn't malfunctioning. If the outlet is connected to a wall switch, ensure that the switch is turned on.
S
sarahgallagherSep 4, 2025
Why the image on the screen does not move when I move the item that I am reading on Freedom Scientific Magnifiers?
- M
  Michelle WilliamsSep 4, 2025
  Press the orange FREEZE FRAME button to turn off Freeze Frame mode.
D
David ReedSep 6, 2025
What to do if I can't swivel the monitor and control panel on Freedom Scientific TOPAZ?
- B
  Bradley HillSep 7, 2025
  First, raise the monitor height so that the control panel clears the camera. Then, you should be able to move the monitor to the left or right.
I
ihillSep 9, 2025
How to fix bouncing white box on the LCD screen (white box that reads digital, check signal cable) on Freedom Scientific TOPAZ Magnifiers?
- K
  Katie LewisSep 9, 2025
  Remove the Freedom Scientific label on the monitor bezel and press the ENTER button. The ENTER button is the second button from the right side of the monitor and has an arrow pointing to the left.