Freedom Won Lite Commercial Series

Questions and Answers

E
elizabeth30Aug 20, 2025
What to do if Freedom Won Lite Commercial Camera Accessories breaker trips randomly?
- J
  James VasquezAug 20, 2025
  If the Freedom Lite Camera Accessories pack voltage is within limits but the main breaker still trips, it's most likely because the current draw is exceeding the battery current limit setting. To check this, measure the current with a tong tester while drawing your maximum typical load. This will determine if you are exceeding the rated current for your specific Freedom Lite model.
J
jenny22Sep 1, 2025
What to do if Freedom Won Camera Accessories BMS does not stay on?
- A
  Aaron StephensonSep 1, 2025
  If the BMS (indicated by battery SoC display lighting up) does not stay on after the ON button is pressed, check whether the red error light is illuminated on the SOC display when the ON button is held in. You can try to reset the error by pressing the RESET button for about 2 seconds while you hold the On button in. If the battery has been discharged to critically low level, remove all potential loads from the battery and switch off the inverter(s). Then try to switch on the BMS. If the battery has been charged to critically high voltage level, usually leaving the battery for an hour will allow the cell levels to drop down within acceptable levels and allow the BMS to be switched on again. Also, ensure that the Emergency Stop button is released if fitted.
E
Earl LeeNov 10, 2025
Why does the main breaker switch keep tripping on my Freedom Won Lite Commercial?
- J
  Jennifer MillerNov 10, 2025
  If the main breaker switch keeps tripping each time you attempt to switch it on, and you're using multiple Freedom Lite Camera Accessories in parallel, the battery you're trying to switch on might be at a different voltage than the others. Ensure the voltages are similar, within 2V of each other, on all batteries when switching them onto a common DC bus. Alternatively, the Battery Management System might not be switched on. Press the ON button for 3 seconds until the SoC Display remains illuminated after releasing the button. Another potential cause is high inrush current on certain inverters. If possible, pre-charge the DC bus by switching on the solar charge controllers (if present and in daytime). If that's not possible, switch on the AC feed into the inverter and then switch on the inv...