then return to their standby state.
Repeat the binding steps above if a binding attempt fails.
MoVI Controller Setup
To use the MōVI Controller with FRX Pro you must change the MōVI Controller's Radio
Type setting to 'USB'
To access this setting navigate to the MōVI Controller's Radio Config menu and
use the Menu Set knob to change the Radio Type to 'USB'
Once the setting has been changed, 'Write' it to the MōVI Controller's memory by
selecting the 'Write' field on the next line and pressing the Menu Set knob.
To use the old MC-RX with this MōVI Controller, you must set the Radio Type back
to 'Internal'
Use of FRX Pro requires a MoVI Controller that is updated to [v4.1.X or newer](https://freeflysystems.com/support/movi-controller-support).
Use of FRX Pro requires a MoVI gimbal that is updated to [v2.0.X Blackjack or newer](https://freeflysystems.com/support/movi-pro-support/beta).
Running dual MōVI Controllers using FRX Pro is not possible, due to the FRX Pro's large
To Next Page
Loading...