position of pedal may have change when gyroscope has not warmed up. If
the position of pedal is in the wrong position when started, adjust by
repeated power on-off.
2. Balance Output of Freego
Computer balance will start immediately after you press the pedal switch of
Freego. If you keep pressing the pedal switch, the computer balance will
always start, the computer will keep balance even if the pedal switch is
restored (the pedal switch is pulled up) when at a low speed. In case driver
needs leave and push the Freego. Please pay attention, Freego will have a
tendency to move forward even if without load, the Freego will keep
computer balance. Therefore do not leave Freego without a driver on the
road, Freego will run automatically by itself until it falls down. It is normal.
3. Freego Standing
When you want to make Freego stand after driving, you can turn off power
and put bracket down
Turn the power off immediately if Freego falls into water accidentally. Do
not drive it again if you are not sure. If any fault does not correct itself the
Freego weighs 56kg. You can pull it easily without power home and then
contact us; we will give you after service guide.
Lock Freego to prevent running by accident. Power off then lock, when you
power on again and press the pedal switch, there will be no action, it means
your Freego is locked.
To Next Page
Loading...
