Please turn off the power switch then lock the switch, in case of accidental
starting.
3. Replacing Fuse
The fuse of the Freego is 50A car fuse. The fuse may burn after an overload
or when crashed. After switching on and there is no action, and the indicator
is off, check fuse if it is burnt. Open the fuse cover at the back of the body
with a screwdriver, take out the fuse using clamp and replace with a new
fuse.
4. Fastening Nut of Tire
Pay attention to the screws on wheels, regularly check, if it is loose tighten
with a 18mm spanner to 108 torque.
5. Maintenance of Tire
Normal air pressure is basic to guarantee safe driving. The standard tire
Pressure is 100 kpa = 1.0 bar = 1.02kg/cm
2
, (as recommended), It is
necessary to check the tire pressure regularly, under inflation and excessive
inflation will cause unequal tire wear, which influences comfort and mileage
and shorten the life of tire, under-inflated tires also influence power saving.
Also check for cuts and splits which could cause the tire to deflate at a rapid
rate, which could cause injury to the rider
6. Appearance Cleaning
It is necessary to keep the pedal and body of Freego clean. Please clean any
gravel, solid and mud off after driving. Do not use any corrosive chemical
i.e. petrol to clean Freego. Clean Freego by using a soft cloth and brush and
do not wash Freego with water.
CHAPTER VI
Notice
1. keep Pedal of Freego Horizontal
Freego will consider the current pedal position as its original position setting
when power on. Pedal must not be horizontal after the power is switched on;
it is hard for the driver to stand on Freego if the pedal is not vertical. The
To Next Page
Loading...
