Freeman PFL618C - User Manual

Questions and Answers

J
Jessica QuinnJul 29, 2025
How to fix a Freeman Nail Gun that is not shooting fasteners?
- D
  Dr. Joel Orr MDJul 29, 2025
  If your Freeman Nail Gun isn't shooting fasteners, it could be due to a damaged pusher spring (replace the spring) or using the wrong size of fasteners (use 1/2" crown staples or 1-1/2" to 2" nails).
C
christinaolsonAug 6, 2025
Why is my Freeman PFL618C Nail Gun lacking power and cycling slowly?
- M
  Madison SanchezAug 6, 2025
  A lack of power and slow cycling in your Freeman Nail Gun can stem from several causes: the tool may be too dry (add 2-3 drops of lubrication into the air connector), the air pressure might be too low (ensure your air compressor is set between 70psi and 110psi), or the exhaust could be blocked (clean the exhaust channel).
M
mfoleyAug 14, 2025
What to do if fasteners are jammed in my Freeman PFL618C frequently?
- G
  gabrielgonzalezAug 14, 2025
  If fasteners frequently jam in your Freeman Nail Gun, several factors could be at play. The drive channel might be worn (fix the drive channel), the piston could be broken or worn (replace the piston), or you might be using bent fasteners (remove the bent fasteners and replace them with 1/2" crown staples or 1-1/2" to 2" nails). Also, a dirty magazine (clean magazine), a loose magazine (tighten screws), or incorrect fasteners (verify that fasteners are the correct size) could be the cause.
K
Kristina WongAug 21, 2025
How to stop air leaking in the head cap of my Freeman PFL618C?
- J
  Jessica CooperAug 21, 2025
  Air leaking in the head cap of your Freeman Nail Gun is often due to loose screws (tighten screws) or worn/damaged O-rings or seals (install overhaul kit).