MODEL: PFR2190
RECOMMENDED HOOKUP
CAUTION:
The air compressor must be able to
maintain a minimum of 70psi when the
tool is being used. An inadequate air
supply can cause a loss of power and
REErnan
A WARNING:
Do not connect with an air compressor
which can potentially exceed 200psi. As
tool may burst, possibly causing injury.
Filter
inconsistent driving.
Air
ick
connetctor
TROUBLE SOLVING
Quick
compressor
Q Regulator
PROBLEMS
Air leaking near the
top of the tool or in
the trigger area.
Air leaking near the
bottom of the tool.
Tool does nothing
or operates sluggishly.
Fasteners are jammed
in the tool frequently.
Can not fire the tool
A WARNING:
POSSIBLE CAUSES
I. Loose screws.
2. Wom or damaged O—ringsor seals.
I. Loose screws.
2. Wom or damaged O-rings or seals.
I. Inadequate air supply.
2. Tool is too dry.
3. Exhaust blocked.
4. Wom or damaged O—ringsor seals.
I. Drive channel is wom.
2. Piston is broken or worn.
3. Bent fasteners.
4. Dirty magazine.
5. Loose magazine.
6. Wrong fasteners.
There is no fastener in the magazine.
SUGGESTED
SOLUTIONS
I. Tighten screws.
2. Install overhaul kit.
I. Tighten screws.
2. Install overhaul kit.
I. Make sure the air compressor is
set between 70psi and 115psi.
2. Add about 2—3drops of lubrication
into the air connector.
3. Clean exhaust channel.
4. Install overhaul kit.
I. Fix the drive channel.
2. Replace the piston.
3. Remove the bent fasteners,
replace with the right fasteners.
4.Clean magazine.
5.Tighten screws.
6.Verify that fasteners
are the correct size.
load the fasteners.
Use only Freeman Authorized Repair Parts.For questions please call 1—888—669—5672or visit
our website at http://www.freemantools.com
WEARING PARTS
Repair parts can be ordered from our website: http://www.freemantools.com
08
HTTP://WWW.FREEMANTOOLS.COM
1-888-669-5672
MODEL: PFR2190
MEMO:
HTTP://WWW.FREEMANTOOLS.COM
1-888-669-5672
NE-eman
09
To Previous Page
Loading...
