Freemie ROSE - Add SlimFit Fitmie Inserts; Fitmie Insert Installation; Fitmie Insert Sizing and Compatibility; Connect Cups to Pump

Add SlimFit Fitmie Inserts
4
1 2 3
Suction Cycle
40:00
5
TURBO
100%
3: Join Tubing with Y-Connector.
1: Insert Tubing into large
end of L-Connector.
2: Firmly press small end of
L-Connector into round
Tubing Port on Flange.
Single Pumping:
Remove one Tube and cap one side.
Cap
Double Pumping:
Use both sides of Y-Connector.
Add Cups to Pump
5
9
SlimFit Fitmie
To remove Insert, gently lift
edge and pull out.
SlimFit5 Cups come with 2 sets of Inserts
to add to the 30mm hard Breast Flange.
Size down with the 25mm or 28mm purple
SlimFit Fitmie Inserts. Review Flange Fit
section to make sure you are using the
correct size.
SlimFit Fitmie work only
with SlimFit Cups and come
in sizes 15mm - 28mm.
Push Insert down until it is seated
flat against Flange.
30mm
Breast Flange
Prior to placing Cups in your bra:
1: Turn on pump.
2: Set pump to strongest setting (5/Turbo).
3: Barrier inside Cup collapses and releases
when assembly is correct.
Test Before Use
6
Resting Barrier Collapsed Barrier
If Barrier does not move, reassemble Cups and check all Tubing connections.