9English
Before first use:
1. Read all the points in the paragraph ’Safety instructions’.
2. Lift up the supported pole and push the pole lock
upwards.
3. Install the seat in
the seat hole and
lock it.
4. Install the
back fender by
screwing it in
place.
5. Install the pedal
to the bike
by rotating
the washer
clockwise.
6. Loosen the
handle lock to
adjust the handle
bar horizontal if necessary.
7. Connect the power adapter to the charging port and wall
outlet, the indicator on the adapter will illuminate in red.
Note: Connect the power adapter to charging port firstly.
8. When the charging is complete after 3 - 4 hours, the
indicator on the adapter will illuminate in green.
Note: Charge the battery fully the three first times. Do not
charge it over 6 hours.
Steer the bike:
1. Push forward the power button to turn on the bike.
The dash board lights up and indicate the amount of
electricity
; Push back the power button to turn off the bike.
The dash board light will be off after turning off the power.
2. Rotate the throttle lightly to accelerate the vehicle, and
rotate harder the speed goes faster.
Note: Be accelerate according to the proficiency to
assure safety, and accelerate gradually for initial use.
3. Lightly hold the brake lever to decelerate, hold harder and
the deceleration more obvious.
Note: The left brake lever is for rear brake and the right
one is for front brake.
Note: Be brake in advance when the barriers are in the
front.
4. Press the horn button, the horn sounds up.
5. Press the cruise button while riding to enter the cruise
control mode. In this mode, the bike moves in current
fixed speed even though loosen the accelerator, it won’t
decelerate until brake or re-accelerate. Press the cruise
button and hold for 3 seconds to active or turn off the
front light.
Operation
To Next Page
