9English
Before first use:
1. Read all Safety
instructions.
2. Lift the supported
pole and push
the pole lock
upwards.
3. Install the seat in
the seat hole and
lock it.
4. Install the
back fender by
screwing it in
place.
5. Install the pedal
to the bike by
rotating the washer clockwise.
6. Loosen the handle lock to adjust the handle bar
horizontal if necessary.
7. Connect the power adapter to the charging port and wall
outlet, the indicator on the adapter will illuminate in red.
Note: Connect the power adapter to charging port firstly.
8. When the charging is complete after 3-4 hours, the
indicator on the adapter will illuminate in green.
Note: Charge the battery fully the three first times. Do not
charge it over 6 hours.
Driving the bike:
1. Push the power button forward to turn on the bike.
The dashboard lights up and indicate the amount of
electricity
. Push the power button backward to turn off the
bike. The dashboard light will be off after turning off the
power.
2. Rotate the throttle lightly to accelerate the vehicle, and
rotate harder to increase the speed.
Note: Accelerate in accordance to your ability - to assure
safety. Accelerate gradually for initial use.
3. Lightly hold the brake lever to carefully slow down. Hold
harder to decelerate faster.
Note: The left brake lever is for the rear brake and the
right one is for the front brake.
Note: Drive carefully and make sure you brake in good
time before barriers or other obstacles.
4. Press the horn button and the horn sounds up.
5. Press the cruise button while riding to enter the cruise
control mode. In this mode, the bike moves in current
fixed speed even though you loosen the throttle. It will
not decelerate until you brake or rotate the throttle to re-
accelerate again.
6. Press the cruise button and hold it for 3 seconds to
activate or turn off the front light.
Operation
To Next Page
