1. This manual will help you assemble your
F-18E. Let’s start with the installation of
the main wing panels. Apply an even coat
of 5-minute epoxy to the slot for the
carbon rod in the wing and fuselage and
the root of the wing panel.
2. Press the wing into position on the
fuselage side.
3. Check the alignment of the wing with the
fuselage and wipe off any epoxy that
squeezes out. A small amount of rubbing
alcohol on a paper towel works well.
4. Make sure to check the alignment on the
top of the wing to fuselage joint and wipe
off any excess epoxy. Hold in position until
the epoxy sets. Repeat this process for
the other main wing. We recommend that
you epoxy one wing panel at a time.
Before starting,use the contents list to take an inventory and make sure it is complete.If any parts are missing
To Next Page
Loading...
