8
eng
To Install Seat Pad
– Follow “To Install Seat Pad & Safety Harness
Assembly” in section B.
– Adjust the length of the harness straps until it
fits firmly around your child.
Section D: Toddler Chair Mode –
suitable for 36 months to 36kg / 79 lbs
(refer to illustrations section d)
Removing the safety harness
– (#04 seat unit) Behind the seat pad, press the
button on the inside end of the buckle slot,
located on the inner face of the seat unit, and
slide the buckle out of the slot. Repeat for the
other side. (refer to illustration d1)
– (#08 storage compartment) Behind the seat
pad, pull open the storage compartment door
located on the inner face of the seat unit. Slide
the buckle on the end of the waist strap out of
the buckle slots on either side of the storage
compartment. (refer to illustration d2)
– (#10 crotch cover) Press the button on the
crotch cover and remove from the seat unit
(refer to illustration d3)
– Remove the seat pad and safety harness from
seat unit (refer to illustration d4)
– Replace the crotch cover by snapping into seat
unit (refer to illustration d5)
– Replace the seat pad on the seat unit (refer to
illustration d6)
Seat Unit Height Adjust
– To adjust seat height, disengage the swivel/
height resistor.
– To adjust the height down, lift both A & B
triggers simultaneously, and push down
firmly to the desired height position. (refer to
illustration d7)
– To adjust the height up, lift both A & B triggers
simultaneously and release at different
intervals to adjust to the desired position. (refer
to image d7)
WARNINGS:
– In toddler chair mode the seat unit shall
always be adjusted to the vertical upright
position.
– Footrest shall be removed for toddler chair
mode.
To Next Page
Loading...