Self feeding hopper slow juicer SJ-029C
IMPORTANT :
Please wash the juicing parts every time immediately after each used, otherwise the pulp
might stick tightly in Juicing Bowl & Squeezing Auger which will then affect the
disassembly, cleaning and juicing performance.
CLEANING & MAINTENANCE
Fig10
1. Switch off and unplug the juicer.
2. Wash the disassembled parts (Fig 10) with water. If the meshes are clogged with pulp, please use
the provided cleaning brush to remove the dregs.
Attention:
•
Do not use iron wire brush, abrasive or sharp object tool to clean theunit.
•
Please do not use water above 40°C.
3.
In case there is any residues remained in the mouth of the pulp spout, please pull out the
silicone valve as shown in (Fig 11) below and clean under running water.
Fig 11
To Next Page
Loading...