THG THB HCE HDNL English
31
• The refrigerator circuit’s exterior (compressor,
condenser, connection tubes, and remaining
components) must be cleaned with a soft
brush or vacuum cleaner.
• Pay special attention while cleaning the
condenser. If obstructed, it will affect the
equipment’s performance.
• While cleaning, be careful not to twist the tubes
or disconnect cords.
Cleaning Glass Doors:
• Cleaning with abrasive microfibers cloths and all types of coarse sponges is not
allowed.
• Make sure to avoid large quantities of water from being applied on glass surfaces
when being cleaned and that the surfaces are thoroughly dried afterwards.
• You can only clean the inside of the lid with a soft cotton cloth moistened with the
following solution: 90% distilled water + 10% isopropyl alcohol to clean the entire
area. Cleaning products can destroy the coating.
• The outer part of the lid can be cleaned with normal cleaning products.
NOTES:
• Do not use abrasive materials or mops as they will definitively damage the
equipment’s surface.
• Do not remove fixed parts for cleaning. If necessary, they must be cleaned by
qualified personnel.
• Do not use hot water on glass doors while they are cold: the temperature difference
might break the glass.
Component Replacement:
If any component of the equipment is damaged, it must be replaced by personnel
properly qualified for this task.
10. Problem Resolution Guide
10.1 The equipment is not working
• Check if there is electrical current.
• Check if the plug is properly inserted in the source outlet and if the voltage and
frequency are appropriate for operation.
10.2 The temperature is not satisfactory
• Check if the equipment has been connected long enough to have reached
operation temperature.
• Check if the equipment is away from heat sources.
• Check if the doors are properly closed.
• Check the temperature regulation.
To Next Page
Loading...