FRIDEN STW - Page 21

6-18-80 FRIDEN CALCULATING MACHINE Co., INC, Page 21
BASIC
ADJUSTMENTS
—
NONSEQUENCE
MODEL
STW
41. LEFT HALF ACCUMULATOR CLEAR RACK:
In
Clearing
Position,
there
should
be
a
slight
amount of clearance between Bumper Aand Stop
B on Carriage at end of travel. Adjust Bumper
A.
45. LAST ORDER POSITIONER: Return Clear
Key depressed and Carriage shifting out of Sec-
ond Pasition (handcrank). Clear Pawl A should
clear Clear Slide B .010 ta .020. Adjust Last
Order Positioner C.
42, OPTIONAL CLEAR SLIDE ASSEMBLY: In
Home Pogition, Optional Clear Latches A should
be free to move in and out of position behind
- Studs on Slide B. Adjust Bumper C.
46. OPTIONAL AUTOMATIC CLEAR PAWL AS-
SEMBLY: With 9's in Accumulator Dials, depress
Return Clear Key and turn slowly by handcrank.
All 9's should clear outand there should be .610
to .020 overtravel of Accumulator Clear Rack A.
Adjust Eccentric B,
43. OPTIONAL CLEAR SLIDE, SECOND AD-
JUSTMENT: In Clearing Position, there should
be a slight clearance between Bumper A andend
of Screw B at end of travel. Adjust A.
44, ACCUMULATOR DIALS ZERO STOPSLIDE:
In Home, Position, there should be .015 to .025
clearance between points on Slide A and Zero
Cams B. Adjust Stop C.
47. MICRO-SWITCH: Switch should make con-
tact and motor should start well ahead of the re-
lease of the Clutch. As a check on this adjust-
ment, motor should start when the Plus Bar is
depressed 3/16" to 1/4". Adjust by forming
Switch Lever A.