5
F900 AUTOMATIC CITRUS JUICER
Carefully unpack all parts of the juicer including those in the polystyrene packaging
Before the juicer is used for the first time, it must be Cleaned as described in the section
Cleaning and care.
1. Fit the drive stem onto the drive shaft on the base. Close the lid; ensure that it is
heard locking into place. All parts must be bone dry.
2. Fit the juice container so that the ▼ and open padlock marks are aligned.
3. Fold the juice outlet up.
4. Lock the juice container by turning it clockwise, so that the ▼ and closed padlock
symbols are aligned and the juice container is heard locking into place. If the juice
container turns during operation, it is not properly locked. In that case, switch the
appliance o, lock the container properly and then continue.
5. Fit the pulp sieve onto the juice container.
6. Fit the juicer dome over the pulp sieve and onto the drive shaft.
7. Fit the lid insert into the lid and push it firmly down until it clicks.
8. Push the hinge opener on the juice container down and fit the lid into the hinge.
9. Place a suitable container under the juice outlet and fold the outlet down. There is a
power-cord storage compartment in the base.
10. Connect the appliance to the mains. The juicer is now ready for use.
HOW TO ASSEMBLE
For a YouTube video - scan this QR code or
go to this link:
https://www.youtube.com/c/Fridja
To Next Page
Loading...
