37 PB
ROUTINE MAINTENANCE
Remove And Install The Front Cover
WARNING
ELECTRIC SHOCK HAZARD
Disconnect power to the unit before
servicing. Failure to follow this warning
could result in serious injury or death.
Remove the decorative front cover.
1. Using the tool provided (see gure below), loosen the four (4) captive screws as shown in gure 401
B
Location of the
Grill Removal Tool
Install the decorative front cover.
1. Tighten the four (4) captive screws as indicated by the arrows in the gure above before closing the front panel
(do not over tighten). Ensure the lter is in place. Make sure curtains do not block the side air intake
2. Notes on reattaching the decorative front cover:
Align the cord notch over the cord and center the fresh air lever.
Align the cover over the User Interface (UI) to ensure it is clear around it and it does not depress any buttons. If not
installed correctly the wrench alert symbol could ash.
Figure 401 (Remove and Install the Front Cover)
To Next Page
Loading...
