★
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity
(+/-).
4. Reinstall the battery cover plate
Notes:
When replacing the batteries, do not use old or different types of
batteries, it may cause malfunction.
If the remote controller will not be used for a long time, please remove
batteries to prevent batteries from leaking.
Remote should be kept
3 feet
away from the TV set or stereos.
If the remote controller does not operate normally, remove batteries and
reinsert after 30
seconds. If abnormal operation continues, replace the
batteries.
Diagram for removal of
batteries
Replacement of Batteries
Press "+ " and "-" buttons simultaneously
to lock or unlock the keypad. If the remote
controller is locked, is pressing any button, blinks
three times.
℃
℉
SLEEP:
LIGHT:
16
Press this button to go into the SLEEP operation mode. Press it again to cancel this
Press LIGHT button to turn on the display's light and press this button again to turn off
disappears.
Combination of "+" and "-" buttons: About lock
14
15
or DRY mode to maintain the most
comfortable temperature for you.
Remote Control Instructions
17
Combination of "MODE" and "-" buttons:
, press "MODE"
displayed. In this case,
Allows you to toggle between Fahrenheit and Celsius.
When the unit is OFF
and " - " buttons simultaneously to switch between and .
To Next Page
Loading...
Need help?
General
