Why can't I adjust the set temperature on my Friedrich MRM18Y3J Air Conditioner?
If you cannot adjust the set temperature on your Friedrich air conditioner, it may be operating in Auto mode. Temperature adjustments are disabled in Auto mode, so switch to a different mode to change the set point. Also, ensure your desired temperature is within the range of 61°F-86°F.
Why does my Friedrich MRM18Y3J smell?
If you notice odors coming from your Friedrich air conditioner, eliminate the source of the odor and clean the filter.
What to do if my Friedrich MRM18Y3J Air Conditioner indoor unit is not working?
If your Friedrich air conditioner's indoor unit isn't working, start by removing any obstacles. Ensure you're pointing the remote controller at the receiving window on the indoor unit at the proper angle. Check and replace the remote's batteries. If the unit is damaged, contact your dealer for a replacement. Discontinue use and contact your dealer for a replacement if necessary.
Why is my Friedrich MRM18Y3J's cooling or heating temperature not sufficient?
Insufficient cooling or heating in your Friedrich air conditioner could be due to several reasons. First, check for brownout conditions or low voltage and wait until the power stabilizes. Second, a dirty filter can cause this issue, so clean the filter. Make sure the temperature is adjusted to the proper range. Finally, ensure all doors and windows are closed to allow the system to stabilize.
Why is there no air coming from my Friedrich MRM18Y3J Air Conditioner?
If no air is coming from your Friedrich air conditioner, it might be because the air inlet or outlet is restricted. Remove any obstructions to allow proper airflow. Also, the indoor fan will stop blowing after the set temperature is reached. Finally, the equipment may have a 'Hot start' feature, which allows the outdoor unit to start first so cold air isn't blown into the space.
What to do if my Friedrich MRM18Y3J is not operating?
If your Friedrich air conditioner isn't operating, first wait for the power to be restored. If there is still no power, check the circuit breaker. As a final measure, wait 3 minutes, then try turning the unit on again. If it still doesn't restart, please call for service.
What to do if my Friedrich MRM18Y3J Air Conditioner wireless remote control does not work?
If your Friedrich Air Conditioner's wireless remote control isn't working, it might be out of frequency range. Try removing and reinstalling the batteries, or replace them with new ones.
General| Energy Efficiency Ratio (EER) | 11.0 |
|---|---|
| Voltage | 208/230V |
| Weight | 28.7 lbs (Indoor Unit), 88.2 lbs (Outdoor Unit) |
| EER | 11.0 |
| Operating Voltage | 208/230V |
| Cooling Capacity | 18000 BTU |
| Refrigerant | R410A |
To Next Page
